SmartSafe iSmartINC 605, Инструкция по эксплуатации

Страница: 9 / 16

５
3) Turn on the power switch on the right of the Cabinet.
4) Pour ultrasonic detergent into the ultrasonic cleaning basin so that the needle valve of the injector is
covered by the detergent.
5) Connect the injectors with the right couplers.
Cleaning & testing sequences
A complete cleaning and testing sequence shown below should be followed:
Ultrasonic cleaning
Uniformity/Sprayability test
Leakage test
Injecting volume test
Auto. test
On-vehicle cleaning (for EFI system)
Select the corresponding parameter and set up according for various tests. For detailed operations, please
refer to “Operation” part.
Working with Air
Statement: the equipment can be operated normally without connecting compressed air. This function
is only to enhance the test and cleaning effect.
Note: this function is OFF by default.
We specially designed the WORKING WITH AIR mode, which can improve the spray ability and cleaning effect
of injector. For some injector with serious blockage, it will take a long time to clean them only with cleaning
agent, and the cleaning power can be improved by pulse with pressurized air. At the same time, in the test, it
can be more intuitive to observe the spray ability of the injectors.
1) Install the quick male to the air inlet on the top of the device. See following:
2) Select system function, and then select parameter setting. Change the parameter value of WORK WITH
AIR to Y and save it.
iSmartINC 605 Injector Cleaner & Tester