iSmartINC 402 Injector Cleaner & Tester User’s Manual
3
Control Panel
The control panel is shown in Fig.02
Fig.02
The control panel can be divided into five areas as shown in the following table:
Area
Description
Item selection area
Select a function by pressing a
［ ］
key. The corresponding indicator will come on.
Parameter selection area
Select a parameter by pressing a
［ ］
key. The corresponding indicator will come on.
Parameter setting area
After selecting function and parameter, the user can set the parameter value by pressing
［
◄
］
/
［
►
］
key. (
［
►
］
key is for increasing,
［
◄
］
key is for decreasing.) The set
value will be displayed on LCD.
System control area
System control area below the Item selection & Parameter selection area, which control
the draining stop and run of the equipment.
System pressure control area System pressure control area below the Parameter setting area, which can adjust the
system pressure by pressing [increase pressure] / [decrease pressure] key.
Installation & Connection
1. Ordinary Installation
1
）
Move the machine onto the workbench after
unpacking and loosen the strips on the outlet
hoses.
2
）
Mount the pulse signal cables onto the socket on
the right top side of the machine.
3
）
Take the two adjusting bolts out from the kit and
install them to the press plate on the top of the
glass tube.
4
）
Take the two knurled nuts from the kit and install
them on the adjusting bolts.
5
）
Take the fuel distributor from the kit and install it on
the knurled nuts and tighten them with the pressing
bolts.
Fig.03
1-Outlet hose; 2-Pulse signal cables; 3-Top-supply fuel
distributor assembly; 4-Adjusting bolts; 5-Knurling nut.
2. Ordinary Connection
1) Take the power cables out from the kit and insert it into the input socket at the bottom of the unit.
2)
Take the power cables out from the kit and insert it into the input socket of the ultrasonic cleaner.
