CAT-601S Auto Transmission Cleaner and Fluid Exchanger User’s Manua
l
iii
The equipment is for specialist or qualified
technician use only.
Disclaimer
All information, illustrations, and specifications
contained in this manual are based on the latest
information available at the time of publication.
SmartSafe reserves all the rights to make changes at
any time without notice.
Safety Precautions
Read all service procedures and precautions, installation
instructions and equipment operating manuals thoroughly.
Failure to observe these precautions, or the improper use of
equipment, could result in property damage, serious injury
or death. Never allow improperly trained personnel to
perform these procedures or operate equipment.
Read and understand the User’s Manual before
attempting to operate the CAT-601S.
Do not smoke in proximity to the machine while it is in
operation.
Do not use the machine in proximity to sources of heat
and fire.
Do not expose to direct sunlight or rain, use in
well-ventilated work area only.
Turn off the power after the operation is completed.
When it is in operation, keep the hoses away from
rotating elements and hot parts such as cooling fans,
radiators, etc.
Vehicle exhaust includes various poisonous and
harmful gases (such as carbon monoxide,
hydrocarbon, nitrogen oxygen complex, etc.). Keep the
unit in a well ventilated work area when performing
operation and wear safety goggles, respirator and
clothes.
The operator should keep away from the heat parts
such as exhaust hoses and radiator to avoid the
personal injury.
When disconnecting any connector of the pressurized
fluid pipe, wrap the connector with towel to prevent the
fluid from spurting out.
The children and mental retardation personnel should
keep away from the unit during operation.
The operator should be quite familiar with the shift of
automatic transmission to avoid transmission damage
caused by improper operation.
Always make the drive wheels hanging when cleaning
the transmission or exchanging fluid.
The unit should be placed vertically and should not be
placed upside down.
When changing fluid, the operation should be
performed by properly trained personnel. The quality of
the selected ATF must conform to the direction as
specified in the manual of the auto to be operated.
Otherwise, SMARTSAFE shall not be liable for any
direct or consequential damages.
Note: specifying operations that require
attention when operating the equipment.
Warning: Specifying a possible hazard that
could result in damage to the machine or personal
injury.
FCC Warning
Any Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—
Reorient or relocate the receiving antenna.
—
Increase the separation between the equipment and
receiver.
—
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
—
Consult the dealer or an experienced radio/TV
technician for help.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment .This
equipment should be installed and operated with
minimum distance 20cm between the radiator& your
body.