Smart Power Systems Network Power Management System
34
2. Select an IP Address for the
Smart Power Systems Network Power Management Card
Verify the IP Addresses for the computer and the Network Power Management Card belong to the
same subnet. Refer to the above network information, the possible IP Address for the Network
Power Management Card could be 192.168.20.* (* hereafter represents any number between 1 and
255). Similarly, if the Subnet Mask is 255.255.0.0, the IP Address for Network Power Management
Card could be set up as 192.168.*.* to reach the same subnet with the computer.
To verify there is no other equipment connected to the network using the same IP Address, run
“Ping 192.168.20.240” at the DOS Mode prompt when the IP Address you would like to set is
192.168.20.240. If the response is presented as below, the IP address is most likely not used and
may be available for the Smart Power Systems Network Power Management Card.
Pinging 192.168.20.240 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
Request timed out.
If the response is shown as below, the IP address is in use. Try another IP address until an available
address is found.
Pinging 192.168.20.240 with 32 bytes of data:
Reply from 192.168.20.240: bytes=32 time<10ms TTL=64
Reply from 192.168.20.240: bytes=32 time<10ms TTL=64
Reply from 192.168.20.240: bytes=32 time<10ms TTL=64
Reply from 192.168.20.240: bytes=32 time<10ms TTL=64
