SwitchLinc V2 Relay User’s Guide
ADVANCED FEATURES OF SWITCHLINC RELAY
Restoring Power to SwitchLinc Relay
SwitchLinc Relay stores all of its settings in non-volatile memory, so they are not lost even when power is
removed. In the event of a power loss, SwitchLinc Relay will automatically return the load being
controlled to the state it had before the power was interrupted.
Resetting SwitchLinc Relay to Its Factory Default Settings
The factory reset procedure can be used to clear SwitchLinc Relay’s memory and restore its factory
default settings. This procedure will clear the unit of all INSTEON Links, and any programmed X10
Primary Address or X10 Scene Addresses.
1. Before resetting a SwitchLinc Relay that has been linked to an INSTEON Controller, be sure to unlink
it from the Controller first. See
Unlinking SwitchLinc Relay from an INSTEON Controller
, above.
2. If you are using SwitchLinc Relay to control any INSTEON Devices other than the light it is wired to,
unlink those Devices from SwitchLinc Relay. See
Unlinking a Controlled INSTEON Device from
, above.
3. Press and hold the Paddle Top for 10 seconds -- then release.
4. Tap the SET Button all the way in -- then release.
5. Push the SET Button all the way in and hold for 10 seconds -- then release.
6. A few seconds after you let up on the SET button, SwitchLinc Relay will turn the light it is wired to fully
ON, indicating that the factory reset is complete. SwitchLinc Relay is now reset to all the default
settings and ready for fresh programming and use.
NOTE
Note:
Unless they have been unlinked, INSTEON Devices that have been previously linked to
SwitchLinc Relay will still respond to paddle presses, even after a factory reset. The reason is
that the INSTEON Devices themselves have not been unlinked from SwitchLinc Relay. Follow the
procedure
Unlinking a Controlled INSTEON Device from SwitchLinc Relay
, above, to unlink
individual INSTEON Devices.
Page 19 of 32
