Smartgen GENSET CONTROLLER MGC310, Руководство пользователя

Страница: 16 / 27

MGC300 Genset Controller User Manual
MGC300 Genset Controller Version 1.1 2020-01-04 Page 16 of 27
7 DEFINITION AND RANGE OF PARAMETERS
7.1
PARAMETER SETTING CONTENTS AND RANGE
Table 7 Controller Configuration Parameters
No. Items Parameter Range Default Description
P00 Mains Normal Delay (0-3600)s 10 Check time duration for Mains voltage from
abnormal to normal or from normal to
abnormal to be used for ATS transfer.
P01
Mains Abnormal
Delay
(0-3600)s 5
P02
Mians Under Volt
Value
(30-6000)V 184
If the voltage sample is lower than it, Mains
under voltage is considered; When it is set
30V, under voltage signal shall not be
detected; return difference is 10V;
P03
Mains Over Volt
Value
(30-6000)V 276
If the voltage sample is higher than it, Mains
over voltage is considered; When it is set
60000V, overvoltage signal shall not be
detected; return difference is 10V;
P04 Mains Options (0-1) 0 0: AMF 1: Display Only
P05 Start Delay (0-3600)s 1
Time duration from mains abnormal or
remote start signal is active to genset
startup.
P06 Stop Delay (0-3600)s 1
Time duration from mains normal or remote
start signal is deactivated to genset stop.
P07 Start Attempts (1-10) times 3
It is maximum start attempts when starter
fails to start. When it reaches set attempts
controller shall send out start failure signal.
P08 Pre Heating (0-300)s 0
Pre-heating plug pre-energization time
before starter is powered on;
P09 Cranking Time (3-60)s 8 Time for starter to be energized every time.
P10 Crank Rest Time (3-60)s 10
The waiting time before second power up
when engine start fails.
P11 Safety On Delay (1-60)s 10
Alarms for low oil pressure, temp. high,
under speed, under frequency and under
voltage are deactivated.
P12 Start Idle Delay (0-3600)s 0 Time for genset idle running at starting;
P13 Warming Up Time (0-3600)s 10
Warming-up time before breaker close after
high speed running for genset.
P14 Cooling Time (3-3600)s 10
Radiating time before genset stop after
genset is unloaded.
P15 Stop Idle Delay (0-3600)s 0 Time for genset idle running at stopping;
P16 ETS Solenoid Hold (0-120)s 20
The time for Stop electromagnet to be
energized before genset stop.
P17 Wait for Stop (0-120)s 0
Time from idle delay to complete stop when
ETS stop output is set to 0; when the output
time is not 0s; it's time from ETS stop end to