SMARTEYE Multi-netx, Руководство пользователя

Страница: 33 / 76

SMARTEYE
Netx Ethernet IP Control Unit User Manual Page 27
Filename: netx IP Platform User Manual R0 .doc
…
In Control
A
M
8.2.1 Serial configuration Commands
Typing the ‘conf’ command puts the control unit into configuration mode. Here operating
parameters for the unit can be configured.
[SMARTEYE]>conf
COMMANDS:
1 = General Configuration
2 = Configure Auxiliary Port
d = Default Configuration
e = Erase Flash Configuration
s = Save & prompt for Restart
r = Restart (reboot this unit)
exit = Exit Configuration and return to OS shell
conf %
Pressing the enter key without input, displays the available commands as shown above.
The control unit’s configuration parameters are divided into two groups.
1. General Configuration
2. Configure Auxiliary Port
For a list and definition of every configuration parameter, see the next section.
The General Configuration group is where the Netx control unit’s IP, Subnet Mask and Default
Gateway parameters are set. Once changes have been made, use the ‘s’ command to save the
configuration parameters and restart the unit.
To make configuration changes, enter the number of the group to be edited at the “conf%”
prompt. For example typing a ‘1’ at the “conf %” prompt will enter the General Configuration
menu. Once in the menu, simply type your choice at the ‘?’ prompt.
8.2.1.1 General Configuration Example
COMMANDS:
1 = General Configuration
2 = Configure Auxiliary Port
d = Default Configuration
e = Erase Flash Configuration
s = Save and Restart
exit = Configuration and return to OS shell
conf % 1
Configuration
Description: [TNET – New Reader]