SMART PCIE-6001, Инструкция по установке и эксплуатации

Страница: 30 / 48

30 PCIE-6001 Installation and Use (6806800U73B)
Hardware Preparation and Installation
Hardware Preparation and Installation
2.6.2 M.2 AHCI or NVMe SSD Removal from the PCIE-6001 Card
To remove M.2 AHCI or NVMe SSD modules from a PCIE-6001 card:
1. Remove M.2 shoulder screw.
2. Remove M.2 module.
2.7 PCIE-6001 Card Installation and Removal
This section contains the PCIE-6001 card installation and removal procedures.
2.7.1 PCIE-6001 Card Installation
To install the PCIE-6001 card, perform the following steps:
1. Use anti-static pads and attach an ESD strap to your wrist. Attach the other end of the
ESD strap to an electrical ground (For more details, refer to the section
Precautions on
page 29 ).
2. Identify the system in which the PCIE-6001 card is to be installed.
3. Remove the system cover.
4. Insert the PCIE-6001 card into the PCIe slot, secure it, and ensure that the card is
properly fitted in the PCIe slot.
NOTICE
Shipping the card along with a server is not recommended.
If you still need to ship the card along with the server, ensure the card is properly
secured in the server. Check if necessary precautions were followed to keep the
card resistive against wobbling. Otherwise, there are chances of card getting
damaged.
For more information about securing the PCIe card in a server, refer to MaxCore
product documentation.
You must allow the card to cool for 30 minutes, before removing it. In case you try
to touch the card, the heat sink could be hot enough to burn your skin.
For detailed information about the PCIe card installation, refer to MaxCore product
documentation.