Do not install the opener with any cables connected. When mounting
the opener to the bracket do not have any cables connected as the
control box may activate the powerhead leading to serious injury if you
are caught in the drive chain/sprocket.
Only conect the cable after the drive unit is installed satifactorily and
you are no longer in direct contact with the motor.
Do not set up or operate the roller shutter opener using unregulated
power from a generator or similar source. Doing so will cause
irrepairable damage to the control board and
will
void the warranty.
-5-
Installation
Remember
there are specific standards that have to
be strictly followed regarding the safety of electrical
installations of automatic gates and doors.
As well as the legal requirements and standards that
must be adhered to, please take note of the following
points to ensure maximum safety and reliability of your
installation.
1.
Prior to installing check the surrounding environment.
Carefully evaluate any hazards there could be from
physical damage (transiting vehicles, parts of trees
falling etc.), possible contact with foreign bodies
(insects, leaves, etc.), Flooding hazards or any other
exceptional events.
2.
Check that the mains voltage is the same as that
given on the rating plate and in this manual.
3.
Check there is suitable electrical protection against
short circuits/power spikes and proper earthing on the
mains supply.
Remember
the unit has mains voltage running through it
(electrocution hazard, fire hazard, etc).
4.
Take care with the control unit; parts may be subject
to damage if abused.
5.
Make sure you have all the necessary materials and
that they are suitable for this kind of use.
6.
Read all the instructions thoroughly and make sure
they are understood before attempting to install the
Smart Roller Shutter Opener.
7.
Before starting the installation, carefully analyse all
the risks relating to automating the door. Verify that
the door to be automated is in a sound condition
and that the mechanisms are in good working order;
observe the safety margins and minimum distances.
8.
Evaluate with particular care the safety devices to be
installed and where to install them; always install an
emergency stop device for interruption of power to the
opener if required.
9.
Once the risks have been analysed, install the Smart
Roller Shutter Opener and relative safety devices,
emergency stop and/or photoelectric cells.
Important:
For additional safety Smart Openers Pty Ltd
strongly recommends the fitting of Photo Electric Safety
Beams on all installations.
10.
When installing the Smart Roller Shutter Opener,
strictly follow all the instructions given in the
instruction manual. If some points or procedures
in this manual are not very clear do not install the
unit until all doubts have been cleared up with our
technical department.
© June 2009 Smart Openers Pty Ltd