8.2 RCF Operation
(1) Turn on the power switch.
(2) Set an RCF (Relative Centrifugal Force) value.
• Press the select button and choose speed unit × g, the speed symbol will flash into RCF value
input status
• If no button is pressed after the speed value has flashed for 5 seconds, the input mode will be shut down
• Rotate program button to input a RCF value, RCF increment is100 ×g
(3) Set operating conditions
• The other operation, please refer to the section 8.1
8.3 Pulse Operation
This function is used to remove the residual samples adhered on the interior of the tubes.
Note: The button works only when the rotor stopped and the door is locked.
(1) Turn on the power switch and load the rotor to the shaft, tighten the rotor lid and make sure it is in
secured position, and then close the door.
(2) The centrifuge gets into preparation mode and displays last running values. The values can be reset.
(3) Press knob and hold, the centrifuge will speed up to the setting speed. While releasing
knob during acceleration, the centrifuge will start to decelerate and stop.
12
SLS Lab Basics 12 Place Microcentrifuge User Manual
Select
Pulse
Pulse
9. Maintenance
CAUTION:
•
If you do not follow the recommended instructions for cleaning or disinfecting, this may damage the
centrifuge
(1) Centrifuge
• If the centrifuge is exposed to ultraviolet rays for a long time, the color of the doors may change or the
label may come off. After using, cover the centrifuge with a piece of cloth to protect it from
direct exposure
• If the centrifuge needs cleaning, clean it with a cloth or sponge moistened with a neutral detergent
solution
