Technical Specifications
Product Type:
570
Intended use:
Abdominal muscle stimulator
Classification:
• Internally powered equipment, Type BF applied parts.
• This product is intended for continuous operation. i.e. operation in normal use, for an unlimited period of time,
without the specified limits of temperature being exceeded.
• This product is not suitable for use in an oxygen-rich environment.
• This product is not suitable for sterilisation.
• Protected against ingress of water, as per IP22.
Waveform:
Symmetrical bi-phasic pulse waveform when measured into a resistive load.
Note:
• The signal gradually increases to a peak intensity level at the start of the contraction phase (i.e. ramp up) and
gradually decreases to nothing at the start of the relaxation phase (i.e. ramp down). When a GelPad contact
problem is detected, the signal ceases.
Environmental Specifications:
Operating Range:
Temperature: 5 to 40˚C / 41 to 104˚F
Humidity: 15 to 93 % RH (non condensing)
Atmospheric Pressure: 70 to 106kPa
Transport & Storage Range:
Temperature: -25 to +70˚ C / -13 to +158˚F
Humidity: 10 to 93% RH (non condensing)
Atmospheric Pressure: 50-106kPa
The Output Frequency indicates the number of pulses per second transmitted by the controller. This is measured in
hertz, which is indicated by Hz”.
Output (RMSA) means the maximum output root mean square current for each channel.
Output (RMSV) means the maximum output root mean square voltage for each channel.
The controller contains 1 x 4.2V (max.) Li-Po battery.
Caring For Your Belt
Your belt can be washed, but you must first remove the controller and GelPads and try to avoid immersing the holster
in the water. Always follow the instructions on the label when washing the belt.
Never machine wash your belt. Always hand wash in lukewarm water. This protects the internal wiring from
damage in the washing machine. You should take care even when hand washing and never wring the belt to
remove water.
Do not use bleach when washing the belt.
Do not dry clean your belt.
Do not tumble dry your belt. Dry the belt on a flat surface. Do not dry it over anything hot. (e.g. a radiator) as
the belt contains plastic parts. Ensure the belt is completely dry before using it again.
The belt should not be ironed.
Accessories
Under no circumstances should anything other than
SLENDERTONE
accessories be used with your
SLENDERTONE
CONNECT ABS
product (Type 570). Any others may not be compatible with your product and could degrade the
minimum safety levels. You can purchase all accessories from www.slendertone.com or by calling customer care.
SLENDERTONE CONNECT ABS
Belt:
SLENDERTONE ABS
GelPads:
• 1 large, square GelPad (Type 732)
• 2 small, oval GelPads (Type 733)
USB Cable:
Type A to Micro B USB Charger
17
16
E
ng
lish
Slendertone Connect IM Rev 4_ML Book 07/03/2016 16:37 Page 17