SkyWave IDP-680, Руководство по оборудованию, Страница: 38 / 64

IDP 600 Terminal Series - Hardware Guide
T200, Version 02 28 © SkyWave Proprietary
Note: Remember to leave enough cable slack near the terminal for strain relief so as
not to introduce any additional force on the connector. SkyWave recommends
securing the cables during installation.
Figure 22 Sample Cable Placement in a Vehicle Cab
Run the cable assembly following the steps below.
1. Use tape to temporarily secure the terminal in its final location while you run the
cable.
CAUTION Do not drill any mounting
holes at this time.
2. Search for vehicle cab entry points on the side of the vehicle closest to the fuse
panel. This will help to minimize the amount of cable routed along the floor of
the cab.
Where possible route the cable through existing holes in the floor or the firewall
of the engine compartment.
3. Route the cable starting from the terminal to the fuse panel or battery source.
Note: SkyWave recommends that you tape cable ends to prevent dirt from collecting
on the contacts.
4.6 Mount the Terminal
CAUTION Painting terminals or antennas may interfere with their
performance.
The terminal will either have a bottom connector or a side connector.
Note: The Solution Provider is responsible for providing mounting instructions if the
mounting is to be done using tools or configurations that are different from the
ones described in this document.
Note:
It is the installer’s responsibility to comply with local electrical codes.