ASSEMBLY
ASSEMBLY (PUTTING THE TRAMPOLINE AND ENCLOSURE TOGETHER)
IMPORTANT ASSEMBLY INFORMATION
• Need phillips screw driver (included with trampoline) and 2 adjustable wrenches (for putting the trampoline together).
A
rubber
mallet is also recommended to make assembly easier.
• Assembly requires two adults. Keep children away from the trampoline and enclosure until they are completely put together.
• Use gloves to protect your hands from pinch points during assembly.
• Make sure that the trampoline is properly put together, with the frame pad correctly laid out, before you put together the trampoline
enclosure.
• The assembly steps refer to parts by their descriptions and key numbers (see the
PAR
TS LIS
T
on page 13 and make sure that all
listed parts are included. If a part is missing, refer to ORDERING REPLACEMENT
PAR
TS at the bottom of page 13.
TRAMPOLINE PLACEMENT
1. Place the trampoline and enclosure on a level surface before you use it.
2. Adequate overhead clearance is essential.
A
minimum of 24 feet (7.3 meters) from the ground is recommended. Provide clearance
from wires, tree limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline and enclosure
away from walls, structures, fences, and other play areas. Maintain a clear space on all sides of the trampoline and enclosure.
3. Use the trampoline in a well-lighted area. If the trampoline is indoors or in a shady areas you may need to use artificial (electrical)
lighting in the area.
4. Secure the trampoline and enclosure against unauthorized and unsupervised use.
5. Remove any objects from under the trampoline and enclosure.
6. The owner and supervisors of the trampoline are responsible to make all users aware of practices specified in this manual.
7. The trampoline enclosure is only to be used as an enclosure for a specific round trampoline.
13
1.
Make sure that you understand the information in the box at the top of this page.
Repeat steps 1 and 2 five additional times to assemble five
more leg sections.
7
7
7
7
3
Lay
T
op
T
ubes (1) with
T
-joint and Top Tubes(2) with socket
(
A
and
B
in the inset
drawing) on the ground in the positions shown. Make sure the
T
op
T
ubes are turned so the small holes (spring holes) are fac-
ing the ground.
Insert one end of the
T
op
T
ube (1) with
T
-joint(A)into the socket
of the other
T
op
T
ube (2) with socket(B). The Top Tube
should now appear as shown in step 2, below.
2. The peak of the Leg Brace should point toward the ground.
Insert leg Extension (3) into the Leg Brace (4) secure
with screw (7). Insert Leg Extension (3) into Leg Brace
(4) secure with screw (7). Insert one Leg halfway into the
T
-joint. Pull out on other leg and insert into the Socket
Press
down on both Legs at the same time and fully insert them into
the
T
-joint and socket
tightened by screw (7).
Note:
Y
ou may need to pull outward on the Legs as you insert
them into the
T
-joint and socket Leg warning sticker should face out.
Trampoline Assembly
