Skytech Firegear Outdoors FPB-20DBSMT-N, Инструкция по установке и эксплуатации

Страница: 22 / 38

REV. 11-16-18 Page 22
Round Flat Disc Fire Pits
INSTALLATION OF BATTERY PACK
Requires 4-AA 1.5V
alkaline batteries
Batt
ery c
over
slid
es o
n/off
L
atc
h
in
g
S
o
le
n
o
id
D
C
M
o
to
r D
riv
e
Slide Switch
to Latching
Solenoid
Fig. 21. Slide switch on latching solenoid
Fig. 22 Cover plate installation
SECTION C THERMOCOUPLE FLAME SENSE (TFS) INST
ALLA
TION
Battery Pack
Cover Plate
(Rear View)
It is important to locate the battery pack where it is easy to access for battery replacement and service. The best location
is on the outside wall of the fire pit enclosure. A plastic junction box is provided for the installation of the battery pack and
a weather-proof cover to protect it from the outside elements.
1. Install (4) AA batteries in to the battery pack by sliding the cover off as shown in Fig. 21. Double check to ensure the
switch on front of the battery pack is in the latching solenoid position. Install the battery pack cover plate by snapping
it into place on the back side of the white cover plate as shown in Fig .22. Note : Be sure the batteries are installed
positive-to-positive and negative-to-negative. If one battery is installed backwards the system will not operate.
2. Install the junction box and secure into position. Note : Junction box should be flush with the finish materials to
ensure weatherproof cover/lid has room (clearance) to open. See Fig. 23.
3. The fire pit has 12-feet of wiring outside of the valve box underneath the burner pan. One end of the wiring has a
4-pin connector. The others are (2) two individual wires (one black and one red) with ¼” female connectors.
4. Feed the wire ends into the junction box and out the front (approximately 4-6 inches) to connect to battery pack (See
wiring diagram on page 27, Fig. 29 and Fig. 23).
5. Open the lid of the weatherproof cover and install the white cover plate with battery pack attached into the weather
proof cover and rubber gasket.
6. Connect the wires from the junction box to the battery pack. Plug the white 4-pin connector into back of the battery
pack and connect the two ¼” female spade wires matching color, red-to-red and black-to-black. Leave enough “play”
in the wires to allow the weatherproof cover/lid and be screwed to the junction box.
7. Secure the weatherproof cover/lid to the two outside holes at the top and bottom of the junction box.
8. Secure the white cover plate and battery pack to the center holes at the top and bottom of the junction box.
9. After the fire pit is installed into the enclosure, the burner and control system should be tested before the media
(lava rock) is installed. Note : Flame height will be very low until media is placed into the burner pan covering the
burner.
FINAL PREPARATIONS
f i r e - p a r t s . c o m