Skytech: 5320P
REV. 8-11-20 Page 3
MODE FUNCTION
NOTE:
Touch anyplace on the screen and the back light will light up and
stay lit for 5 seconds.
To select an operational mode, press the
MODE
(top) button or touch the
MODE
( top)
SECTION
of the touch screen.
• ON
turns the appliance manually ON; the flame icon will appear.
• THERMO
sets the remote to Thermostatic mode.
• OFF
turns the appliance OFF; the flame icon will disappear.
MODE
SET
PROG
Mode: Button
Mode: Touch
Portion
SETTING ºF / ºC SCALE
The factory setting for temperature is ºF. To change this setting to ºC, first press and hold
the
UP
touch button and the
DOWN
touch button on the transmitter at the same time.
Follow this same procedure to change from ºC back to ºF.
Fig. 4
Transmitter functions.
BASIC TRANSMITTER FUNCTIONS AND INITIAL SETUP
• Press and hold the
SET
button, or touch the
SET
(middle) section on the touch screen, for 5 seconds. The hour sec-
tion should begin to flash. (Fig. 5)
• Use the
UP
and
DOWN
touch buttons to select the hour, then press
SET
.
• The minutes will be flashing. Use the
UP
and
DOWN
touch buttons to select the minute, then press
SET
. (Fig. 6)
• The AM PM will be flashing. Use the
UP
and
DOWN
touch buttons to select one of them, then press
SET
. (Fig. 7)
• One of the days of the week will be flashing (above the clock). Select the correct day by pressing the
UP
and
DOWN
touch buttons, then press
SET
. Your time will automatically be accepted. (Fig. 8)
SETTING THE CLOCK
Fig. 5
Hours.
Fig. 6
Minutes.
Fig. 7
AM/PM.
Fig. 8
Days of week.
SET
SET
SET
SET
THERMOSTAT FUNCTION
This remote control system can be thermostatically controlled when the transmitter is in
the THERMO mode (THERMO must be displayed on the screen). To set the desired room
temperature, press the
MODE
button to place the transmitter into thermo mode, then press
the
UP
or
DOWN
touch buttons to select the desired room temperature. The highest set
temperature is 99º F (32º C).
NOTE
: The thermo feature operates the appliance whenever the room temperature varies a
certain number of degrees from the set temperature. This variation is called the “swing” or
temperature differential. This feature lets the appliance turn off and on 2º F (1º C) above or
below the set temperature of the room. This is to cushion the number of times the appliance
is turned ON and OFF. See Swing setting on page 6, Figure 19.
THERMO UPDATING FEATURE - TRANSMITTER
When in thermo mode, the transmitter reads the ROOM temperature every 2 minutes,
checks the room temperature against the SET temperature then sends a signal to the
receiver.
Fig. 9
Thermo mode.
