Press the ENTER button and the amp rate
value will begin blinking. Use the DEC or INC
button to adjust the value to the desired rate.
Follow the instructions provided on your battery
when setting the charge current.
Press and hold the ENTER button for 3
seconds to start charging.
Once charging has commenced, the charger
will display the following real-time information:
battery type, charging current, battery voltage,
working mode, elapsed time and charged
capacity. Once the battery is fully charged, the
screen will read "FULL" and the charger will
emit a ringing sound. You can press the STOP
button at any time during the charging process
to stop charging.
NiMH/NiCd:
This program is only suitable for charging/discharging NiMH/NiCd
batteries. The B6 V2 offers the following NiMH/NiCd charge modes:
Charge, Discharge, Re-Peak and Cycle.
Selecting the Battery Type:
After powering on the B6 V2, press the INC or DEC button repeatedly
until you reach the appropriate program for the battery type you wish
to charge. For this example we have chosen the “NiMH BATT“ or
“NiCd BATT” program. Now press the ENTER button to enter the
desired program.
NiMH/NiCd Charge Mode:
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE
YOU HAVE READ AND UNDERSTOOD ALL OF THE WARNINGS
AND SAFETY INFORMATION CONTAINED ON PAGES 05-07.
After selecting the correct battery type, if the screen does not read
“CHARGE”, use the DEC or INC buttons to change it to the
“CHARGE” mode.
BEFORE YOU BEGIN CHARGING YOUR BATTERY,
MAKE SURE YOU ARE CHARGING NIMH/NICD
BATTERIES. CHARGING LIPO BATTERY UNDER NIMH/
NICD BATTERY PROGRAM WILL CAUSE FIRE.
WARNING!
NiMH CHARGE
CURRENT 2.0A
NiMH 2.0A 6.22V
CHG 00:02:22
START/ENTER
VARIOUS INFORMATION DURING THE PROCESS
Press INC or DEC during the charging or discharging process to
view further pertinent information on the LCD screen.
Final voltage when the program ends.
Input voltage.
Safety timer ON and duration of time in
minutes.
Capacity cut-off ON and value of the set
capacity limit.
Voltage of each cell in the battery pack
when the battery is connected with
balance lead.
Internal temperature.
Temperature probe needs to be connected
to show external temperature.
Real-time status: battery type, battery
cell count, charge current, battery pack
total voltage
,
working mode, elapsed
time and charged capacity.
Cut-off temperature.
3.87 3.89 3.86 V
INC
Ext. Temp ----
Int. Temp 37°C
DEC
Temp Cut-Off
50C/122F
DEC
DEC
DEC
DEC
DEC
End Voltage
12.6V(3S)
IN Power Voltage
12.56V
Safety Timer
ON 120min
Capacity Cut-Off
ON 5000mAh
Lithium Battery Program
(LiPo/LiFe/Lilon/LiHV)
NiMH/NiCd Battery Program
50% 10.20V
00301mAh
C 2.0A
50% 10.20V
00301mAh
C 2.0A
NiMH 2.0A 6.22V
CHG 00106mAh
· 16
B6 V2
17 ·
B6 V2
