Skyjack SJ9233 RT, Руководство по эксплуатации

Страница: 77 / 122

77
SJ9233 RT, SJ9243 RT, SJ9253 RT, SJ9664 RT 221491AFA
Use the maintenance support(s) Section 6 – Additional Procedures
6.6-2 Store the maintenance support(s)
1. Turn the main power disconnect switch to the
on position.
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
2. For model SJ9253 RT:
Raise the platform until the top of the lower
maintenance support is just below or at the blue
mark on the top cylinder mount.
For models SJ9233 RT and SJ9243 RT:
Raise the platform until there is adequate
clearance to retract the lower maintenance
support.
For model SJ9664 RT
Raise the platform until there is adequate
clearance to retract the lower maintenance
support.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder. If you do
not obey, there is a risk of death or serious injury.
3. Retract the top maintenance support (only for
model SJ9253 RT):
a. Go up the MEWP ladder. Maintain three
points of contact on the ladder at all times.
Refer to
Figure 12 .
b. Swing the top maintenance support up until
it locks back into the latch on the scissor
assembly.
c. Go down the MEWP ladder.
4. For all models, retract the lower maintenance
support:
a. Remove the rod from the keyhole at the rear
side of the MEWP.
b. For models SJ9233 RT, SJ9243 RT &
SJ9253 RT:
▪
Pull the rod handle to retract the lower
maintenance support.
For SJ9664 RT:
▪
Push the rod handle to retract the lower
maintenance support.
c. Put the rod back into the keyhole at the rear
side of the MEWP.
5. Fully lower the platform.