http://www.SkyhawkRC.com
http://www.SkyhawkRC.com
(1) Please make calibration outdoor, do not operate it inside building, nearby vehicle environment or magnetic
environment.
(2) Other occasions for re-calibration: the position of electric components has moved or auto hovering
performance is not good.
There are 3 steps to make calibration: make horizontal calibration firstly and later vertical calibration and finally
save compass data. There are related tips under “Settings” bar for every step on GCS software.
Details as below
：
Step 1: disconnect ESC power, connect flight control power, switch to manual mode and pull throttle to bottom.
Step 2: click “Magnetic Compass” button in “Settings” interface.
Step 3: click “Horizontal Alignment” and “OK” button, if user does not want to continue, can click “cancel”.
Step 4: keep aircraft horizontal(hold by hands), make sure the blue LED is still on, and rotate aircraft 5-6 circles,
keep blue LED on while rotation, if the blue LED is off, please stop and adjust aircraft well and continue.
Step 5: click “Vertical Alignment” and “OK” button, if user does not want to continue, can click “cancel”
Step 6: keep aircraft vertical(hold by hands), make sure the blue LED on, and rotate aircraft 5-6 circles, keep blue
LED on while rotation, if the blue LED is off, please stop and adjust aircraft well and continue.
Step 7: click “Save Alignment” and “OK” button.
