SkyAzúl Trimble/LSI GM820, Инструкция по установке и обслуживанию

Страница: 22 / 30

19
SerVice anD inStallation Manual
5.1
5.1
Sensors
Sensors
5.1a replacing Sensor Battery
1. Unscrew the two allen screws about a quarter
of an inch.
2. Insert a flat bladed screwdriver in the battery
cover notch to pry the box away from the
mounting plate. The silicone seal may cause
some resistance.
3. Remove the battery by hand.
4. Remove the remaining silicone from both the
box and the mounting plate.
5. Install the new battery: insert the positive end and
then push in the direction of the positive pole.
6. Apply a non-corrosive RTV silicone all around
the edge of the mounting plate to create a new
seal without bubbles or breaks.
7. Reposition the box over the mounting plate and
screw in the hex screws. do not overtighten
5.
5.
MainTenanCe
MainTenanCe
1/4 in.
1
2
Hex key 5/32 in.
Flat bladed screwdriver
5
New high quality “D”
cell battery: 3.6 V lithium,
or alkaline
Figure: remove the sensor box from the mounting plate
* actual battery life will vary greatly depending on
the application, the frequency of use, the age and
quality of the battery etc.
6
RTV non-corrosive
silicone
Figure: install the new battery and reconnect the data wires
Figure: apply non-corrosive rtV silicone
IMPORTANT!
Protect the interior of the
sensor from dirt and humidity at all times.
!
!
Note: A 3.6 volt lithium “D” cell battery will provide
about two years of battery life for a load cell, while
an alkaline “D” cell battery will provide less than
one year of battery life*.
IMPORTANT! Both lithium or alkaline
batteries can be used, however lithium
battery will last about 2.5 times longer.
!
!
SkyAzul, Equipment Solutions www.skyazul.com 301-371-6126