2. SIM Card:
press the yellow button to open
the slot and put the sim in.
3. GSM
---GSM Antenna Installation
4. GPS
--- GPS Antenna Installation
5. MIC
--- Microphone (monitor) installation
6. EMG
--- Connect SOS button wire
7. VIS
--- Connect Vibrator sensor
8. STATE
---Connect the LED wire
9. Plug
the 20PIN into J1, the “WORK” light starts flashing.
10. Slide
the battery switch to “ON” position
11. Fix:
After installation, check installation of all wires, fix them firmly.
Instructions before Use
1. LED indication:
After installation and power on, the system shows the status:
GSM LED: Flashing fast: indicates that GSM have not registered
Flashing slowly: indicates that GSM works well.
GPS LED: It is on indicating that GPS signal is available
.
WORK LED
：
It flashs to indicate work normally.
2. Factory default setting:
Recipient: Non
User Password: 1234
Status: Unarmed
Time Zone: +/-0000
Shake Alert: On
Unlock while ACC turning off : On
Auto-arm: On
Power alert: On
Move Alert: Off
Over Speed Alert: Off
3. Battery:
Auto-charge when it connects to power supply.
4. GSM/GPS ANT:
Place the ANT in suitable area to get signal well.
- 8 -
