8
Technical User Guide
DA 74C Winch Motor
3.1.2
Mounting in Chimney
Push the inlet funnel vertically upwards into place and lock it
using the four screws and washers included. See Figure 5.
Figure 5: Mounting the inlet funnel in the chimney
3.1.3
Mounting the Cover
Mount the cover before putting the DA 74C winch motor into use. Check that the seal is undamaged and placed
correctly. Then mount the cover. Secure the cover by turning the six click screws, Figure 6
(A)
.
3.1.4
Checking Manual Operation
Check the release when the cover has been mounted. Press the push button, Figure 6
(B)
and check by turning
the swivel shutter.
3.1.5
Before Putting the System into Use the First Time
To provide the winch motors with numbers, attach the included set
of stickers to the flat part of the cabinet, Figure 6.
(C)
Figure 6: DA 74C
3.1.6
Installation of adapter for swivel shutter
Using the DA 74 adapter for swivel shutter, the DA 74C winch motor can be mounted on an axle diameter from
15–20 mm. The DA 74 adapter is ordered separately.
Mount the axle in the shackle and tighten the two nuts.
Torque should be between 15–20 Nm.
Figure 7: DA 74 adapter for swivel shutter
Before the axle and winch motor are connected, both must be in the same position (open/open or
closed/closed).
(C)
(B)
(A)
