20
Replacement Procedures
Service Manual
SKOPE OD1100N
the cabinet, and the two side panels and rear panel packaged together in the cabinet. The high
sign needs to be fitted to the cabinet on site.
Fitting and
Removing the
Sign
Procedure 9: To fit the high sign to the cabinet
1. Remove the high sign assembly from the cabinet.
2. Unpack the sign’s side and rear panel package. There should be three pieces: two identical side
panels, and one rear panel.
3. Loosen the four retaining screws on the roof of the cabinet and fit each sign side panel over the
screws. Slide the sign side panels forward flush with the front of the cabinet, and tighten all four
retaining screws.
4. Fit the rear panel.
•
Remove the two screws from the back of
the side panels.
•
Fit the rear panel across the back of the
side panels by putting the tabs of the side
panels into the top slots of the rear panel,
and clipping each end tag of the rear panel
into the retaining slot in the side panels.
•
Fix the two screws back into each side of
the rear panel to mount it on the side
panels.
5. Attach the high sign assembly onto the
cabinet.
•
Clip the top of the sign into the retaining
slots at the top of both side panels.
•
Clip the diamond-shaped catches at
bottom of the sign into both the bottom
retaining brackets.
Procedure 10: To remove the sign from the cabinet
High sign only
1. Undo the two screws and unclip the two end tags of the sign rear panel from each side panel.
2. Remove the rear panel.
3. Loosen the four retaining screws on the roof of the cabinet.
High and low sign
4. Pull the bottom of the sign forward, and lift the sign up to disengage from the top retaining slot and
bottom diamond-shaped catches on each side of the cabinet.
Back of rear panel
Front of rear panel
Side panel slots
Rear panel tag
Screw
Screw
Diamond-shaped catch
Retaining
slot
