– If the master cylinder is not accessible, remove the engine
control unit from the front wall ⇒ Engine; Rep. gr. 23 or ⇒
Engine; Rep. gr. 24 .
– Lay a cloth under the master cylinder.
– Detach return hose -1- at master cylinder and close with a
suitable tool, e.g. closing tool - T10249/1- .
Note
♦
Do not use the hose clamp - MP7-602- , otherwise the return
hose -1- will be damaged.
♦
During the following work, ensure that no brake fluid lands on
longitudinal member or gearbox. If this is the case, these
points must be cleaned thoroughly.
– Pull out the locking clip -2- on the master cylinder up to the
stop.
Note
On certain master cylinders, the locking clip -2- can also be pulled
out from the side.
– Pull the tube-hose line -3- out of the master cylinder and close.
Vehicles with start-stop system
– Unclip clutch position sender - G476- at master cylinder
-arrow A- and -arrow B-.
– Remove the clutch position sender with fitted electrical plug
connectors from the master cylinder.
Continued for all vehicles
Note
When performing work in the footwell, put cloths on the carpet to
protect it from possible brake fluid spills.
– Removing the footwell vent ⇒ Heating and Air Conditioning;
Rep. gr. 87 .
– If present, remove crash strut
– Put steering wheel in the highest position.
– Remove clutch pedal switch - F36- -1-
.
– Unscrew the top fixing nut -arrow- for the bracket. To do so,
position an long extension on the nut in the opening between
the dash panel -2- and the bottom steering column trim panel
-3-.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
39
