Press on the synchronizer body with the 3rd and 4th gear sliding
sleeve
Press on the inner ring -A- for the cylindrical-roller bearing
– Insert the circlip.
Determining the circlip thickness
– Insert circlip with a thickness of 2.0 mm in the slot of the drive
shaft and push upwards.
– Measure the dimension between the inner ring of the taper
roller bearing and the positioned circlip using a feeler gauge.
– Remove the circlip used to take the measurement.
– Determine thickness of circlip according to the table.
Note
Assign the circlips via the ⇒ Electronic catalogue of original parts .
The following circlips are available:
Measured value
(mm)
Circlip thickness
(mm)
Axial play (mm)
0.05…0.14
2.0
0.05…0.15
0.15…0.24
2.1
0.05…0.15
0.25…0.34
2.2
0.05…0.15
0.35…0.44
2.3
0.05…0.15
0.45…0.51
2.4
0.05…0.10
Press the bearing support for grooved ball bearings onto the input
and output shafts
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
1. Drive shaft
141
