SKILTEC Luxaflex Duette PowerView 9F-2, Информационное руководство

Страница: 7 / 25

ISSUE DATE: NOVEMBER 2017 ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: APPROVED BY: D.ALTIPARMAKOVA PAGE 7
PRODUCT INFORMATION MANUAL
SECTION: 9F-2 DUETTE
®
POWERVIEW
®
MOTORISATION
■
Center the brackets on your marks, then mark each of the screw holes.
➤
Mounting depths vary depending on the fabric cell size. See the following chart for
minimum and fully recessed depth requirements (measured from the front of the sill to
the back of the installation bracket).
IMPORTANT:
For 38mm cell size, 6mm rear clearance is recommended.
➤
Mark both winged screw holes with shallow mounting depths.
➤
Mark the center screw hole when depth permits. The center hole requires 38mm.
See Depth
Chart
Use Center Hole
When Depth Permits
HIGH MOUNT
BRACKET LOW MOUNT
BRACKET DC POWER
SUPPLY
CELL SIZE:
10mm & 20mm 10mm & 20mm 10mm & 20mm
Minimum Reveal Mounting Depth (A): 25mm 25mm 13mm
Minimum End (EB) Mounting Depth: 45mm 45mm 32mm
Minimum Flush Mounting Depth (B): 70mm 67mm 60mm
Minimum Face Mount Vertical Surface: 32mm 32mm 32mm