SKILTEC Luxaflex Duette PowerView 9F-2, Информационное руководство

Страница: 23 / 25

ISSUE DATE: NOVEMBER 2017 ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: APPROVED BY: D.ALTIPARMAKOVA PAGE 23
PRODUCT INFORMATION MANUAL
SECTION: 9F-2 DUETTE
®
POWERVIEW
®
MOTORISATION
Solution IMPORTANT:
A shade will not operate until it is joined to a group.
Check that the correct group number is selected.
Check that the batteries in the remote are correctly inserted and are fresh.
The LEDs that backlight the remote should come on full bright when
■
STOP is
pressed.
Problem The shade is operating slowly or does not raise or lower completely.
Solution
The batteries may be low in the battery wand. Replace the batteries.
Check that the battery wand or DC power supply is securely connected to
the power cable and the cables are not pinched or caught in the headrail or
installation brackets.
Check that the fabric stacks up evenly into the headrail. If not, see “Level the
Rail(s), If Necessary” on page 21.
The shade may need to be reset. Refer to “Resetting the Shade, If Necessary” on
page 18.
Problem
The shade raises or lowers unevenly or the bottom rail is uneven when fully
raised.
Solution
Lower the shade completely to allow it to “self-correct” skewing.
Check that the headrail and installation brackets are level and aligned. Shim the
installation brackets to level the headrail, if necessary.
Adjust the bottom rail. See “Level the Rail(s), If Necessary” on page 21.