SKILTEC Luxaflex Duette PowerView 9F-2, Информационное руководство

Страница: 13 / 25

ISSUE DATE: NOVEMBER 2017 ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: APPROVED BY: D.ALTIPARMAKOVA PAGE 13
PRODUCT INFORMATION MANUAL
SECTION: 9F-2 DUETTE
®
POWERVIEW
®
MOTORISATION
Socket
STEP 3 — Connect the Power Source
NOTE:
When power is connected to the motor, the LED under the manual control button
housing will flash green to indicate the shade is ready for operation.
■
Refer to the appropriate page based on your order.
➤
For a battery wand, see below.
➤
For an optional 18V DC power supply, see “If You Have a DC Power Supply...” on page
15.
➤
For an optional 18V DC power supply with daisy-chain connections, see “If You Have a
DC Power Supply with Daisy-Chain Connections...” on page 16.
If You Have a Battery Wand...
Install Batteries into the Battery Wand
NOTE:
Luxaflex® recommends AA alkaline batteries for use with our battery-powered shades.
These will provide approximately one year of operation. Lithium and rechargeable batteries are
not recommended.
■
Squeeze the cap latch to release the cap and remove it from the battery wand.
■
Install the batteries according to the instructions on
the battery wand label.
■
Replace the cap.
➤
Align the tab with the end of the wand.
➤
Press the cap on until it latches.
Mount the Battery Wand into the Battery Wand Clip
■
Align the battery wand with its socket toward the motor side end cap.
■
Push the battery wand straight up into the battery wand
clip until it snaps into place. Check to make
sure the battery wand is secure.
CAUTION:
Be sure the cable does
not become pinched by the battery
wand clip during installation. Damage
or overheating of components could result.
Tab Slot
Cap
Latch
Battery
Wand
Squeeze