SKILTEC Luxaflex Duette PowerView 9F-2, Информационное руководство

Страница: 12 / 25

ISSUE DATE: NOVEMBER 2017 ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: APPROVED BY: D.ALTIPARMAKOVA PAGE 12
PRODUCT INFORMATION MANUAL
SECTION: 9F-2 DUETTE
®
POWERVIEW
®
MOTORISATION
STEP 2 — Install the Shade
If You Have a Battery Wand Clip...
(Skip this step if your shade will not have an attached
battery wand.)
■
Attach the battery wand clip to the headrail.
➤
Hook the battery wand clip onto the back
channel of the headrail.
IMPORTANT:
Position the clip so that the battery
wand will be between installation brackets.
■
Rotate the clip down until it
snaps into place.
CAUTION:
Do not connect
the battery wand to the
power cable prior to installing
the shade.
Mount the Headrail
CAUTION:
Be sure no cables are pinched by the brackets
or headrail during installation; damage or overheating of
components could result.
■
Fit the front channel on top of the headrail onto the front lip
of the installation brackets.
■
Push the headrail up and back until it snaps into place.
➤
Check that the bottom of the headrail is snapped into
the base of each bracket.
➤
Check that the front lip of each bracket is in the front
channel of the headrail.
■
If any brackets are not installed correctly, release the shade
and reinstall. See “Removing the Shade, If Necessary” on
page 22.
The back of the headrail
snaps into the bracket.
The front of the bracket
fits under the groove.
Headrail
Bracket
Snap
in Place
Good Bad
High Mount
(Standard)
Battery Wand Clips
Low Mount
(Optional)
Front of
Headrail
Battery Wand
Clip