48
Rip Fence Storage
When not in use, the rip fence can be stored
under the left end of the table on the rails.
1. Remove the fence from its in-use position
on the rails.
2. Unlock the rails and extend the rails
approximately 2” to the left of the table
(Fig. 65).
3. Hang the fence upside down under the
rails, using the left side Post C as a position
indicator. Ensure that the auxiliary fence, in
its stored position, is facing away from the
table-saw frame.
4. Latch the front and rear lock levers.
5. Gently slide the rails back toward the center until the fence is close to the table saw frame,
and then engage the rail locking lever.
Miter Gauge Storage
(Fig . 66)
When not in use, the miter gauge can be
stored under the left side of the table.
1. Insert the front end of the miter guide into
the slot located at the bottom of the table
left.
2. Snap the base end of the miter gauge into
the clip.
Push Stick Storage
(Fig . 67)
When not in use, insert the push stick through
the push stick holder.
Fig. 65
Rip Fence
in its Stored
Position (Left
side Post C)
Fig. 66
Clip
Miter Gauge
HEIGHT
+
2
0
15
30
45
22.
5
Fig. 67
Push Stick
Push Stick
Holder
