Skil 3700, Инструкция по эксплуатации и безопасности

Страница: 62 / 112

13. WRENCH STORAGE
Conveniently stores hex wrench, & arbor wrench. (Fig 34.)
14. RIP FENCE STORAGE
Conveniently stores rip fence on two pads on the left side of base
when not in use. Simply align hole on fence with locating pin on
front pad, and press fence down into it’s storage position as shown.
(Fig. 35)
15. RIP FENCE STORAGE
Conveniently stores rip fence when not in use. (Fig. 35)
16. CORD WRAP
Allows you to easily wrap up the cord so it’s out of the way when
transporting or storing. (Fig. 35)
17. RIP FENCE
Exclusive Self-Aligning, Quick-Set rip fence can be easily moved or
locked in place by simply raising or lowering lock handle.(Fig. 35)
Holes are provided in the rip fence for attaching a wood facing AA
Fig. 33). Wood facing should be used when making cuts using
dado blades, or ripping thin materials.
Select a piece of smooth straight wood AA approx. 3/4" thick and
the same size as the rip fence.
Attach it to the fence with two round head No. 10 wood screws CC
1-5/8" long (Fig. 33).
If you are making a rip type cut in thinner materials, the facing
should be attached to the fence so that the bottom edge touches
the top surface of the table. In this situation, the facing must be
lower than the fence. This will prevent thin material from sliding
under the rip fence.
When positioning fence for maximum rip cutting (without table
extension), make sure side of fence housing is even with the side
edge of the table. Do not make rip cuts or dado cuts beyond this
position because the fence can not be properly locked.
Maximum
rip cut capacity is 19 inches.
18. BLADE GUARD
Protects the operator, and must always be in place and working
properly for all thru-sawing cuts. That is all cuts whereby the blade
cuts completely through the workpiece. (Fig. 35)
19. TABLE SAW INSERT PLATE
Is removable for removing or installing blade or other cutting tools.
(Fig. 35)
For your own safety, turn table saw switch
“OFF” and remove plug from power source
before removing the table saw insert.
To remove the insert:
A. Lower the blade below the table surface.
B. Raise blade guard.
C. Remove insert screws and lift insert from pocket in table.
Never operate the saw without the proper
table saw insert (18) in place. Use the table
saw insert provided with the saw for standard blades and
the dado insert (optional) when dado cutting.
20. ACCESSORY TOOL INSERTS
Interchangeable plates inserted into the wings that allow for the use
62.
AA
CC
FIG. 33
13
FIG. 34
0º
5º
10º
15º
20
º
25
º
30
º
35
º
40
º
45
º
21
18
19
FIG. 35
14
8
Y
16
15
17
WARNING
!
WARNING
!
FIG. 33
FIG. 34
FIG. 35