1
2
Removal and Installation
of the Blade
Disconnect plug from power source before
performing any assembly, adjustment or repair
to avoid possible injury.
NOTE:
Clean blade of any excess oil before installation.
1.
Remove the table insert
1
by unscrewing the two screws
2
(Fig. 14).
2.
Raise the blade
3
to the maximum height by turning the
control wheel
4
counterclockwise (Fig. 15).
3.
Remove the arbor nut
5
and flange
6
(Fig. 16).
4.
Clean any sawdust from both blade collars before installing
the blade. Install a 10" (25.4 cm) blade. Install the saw blade
onto the the arbor with the blade teeth pointing toward the
front of the saw.
To avoid injury, do not use a blade larger or
smaller than 10
"
diameter and 5/8
"
arbor.
5.
Install the flange
6
against the blade
3
and thread the arbor nut
5
as far as possible by hand. Ensure that the blade is flush
against the inner blade flange (Fig. 16).
6.
To tighten the arbor nut
5
, use the open-end wrench
7
and
align the wrench jaws on the flats of the flange to keep the
arbor from turning. Place the box-end wrench
8
on the arbor
nut
5
and turn clockwise (to the rear of the saw table) (Fig.
17).
7.
Install the table insert
1
in the table recess. Insert the screws
2
through the holes and tighten (Figure 14).
To avoid injury from a thrown workpiece, blade
part, or blade contact, never operate the saw
without the proper insert in place. Use the table insert when
sawing. Use the dado insert when using a dado blade.
Using Carbide-Tipped Blades
Handle carbide-tipped blades carefully. Carbide
is very brittle and can be easily damaged. Use
caution when you install, use or store the blades. Do not use a
carbide-tipped blade that is bent or has bent teeth, or if the blade
has cracks, is broken, or has missing/loose carbide tips. Do not
operate a carbide-tipped blade faster than its recommended
speed.
Read, understand and follow all warnings and instructions
provided with your carbide-tipped blades.
Adjustments
FIG. 14
8
7
5
6
5
FIG. 16
FIG. 17
WARNING
!
WARNING
!
WARNING
!
WARNING
!
4
3
FIG. 15
34.
Содержание 3305-01
Страница 23: ...This page intentionally left blank 23 ...