Ski-Doo MX Z Iron Dog, Руководство оператора

Страница: 90 / 147

MAINTENANCE PROCEDURES
mmo2013-004-027_a
TYPICAL
1. Coolant tank
2. COLD LEVEL line
Recommended Engine Coolant
Always use ethylene-glycol antifreeze
containing corrosion inhibitors specifi-
cally for internal combustion aluminum
engines.
Cooling system must be filled with
LONG LIFE ANTIFREEZE (P/N 219
702 685) or with distilled water and an-
tifreeze solution (50% distilled water,
50% antifreeze).
Exhaust System
Exhaust System Verification
The muffler tail pipe should be cen-
tered with the exit hole in the bottom
pan. Exhaust system must be free of
rust or leaks. Make sure that all parts
are securely in place.
Check retaining springs condition and
replace if necessary.
The exhaust system is designed to re-
duce noise and to improve the total
performance of the engine. Modifica-
tion may be in violation of local laws.
NOTICE
If any exhaust system
component is removed, modified
or damaged, severe engine damage
may result.
Spark Plugs
Spark plugs inspection or replacement
must be done by an authorized Ski-Doo
dealer.
Engine Stopper
Engine Stopper Adjustment
The engine stopper is located on the
LH front engine support, in front of the
drive pulley.
1. Remove D.E.S.S. key from post.
2. Remove the LH side panel, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT
.
3. Remove drive belt guard, refer to
DRIVE BELT GUARD REMOVAL
subsection in
CONTROLS, INSTRU-
MENTS AND EQUIPMENT .
4. Loosen the three screws retaining
the engine stopper to the engine
support just enough to allow a verti-
cal play (1/2 to one turn).
mmo2010-009-007_a
1. Drive pulley
2. Engine stopper screws
3. Engine stopper
5. Insert a 0.5 mm (.02 in) feeler gauge
in the engine stopper opening (see
illustration).
88
______________