Ski-Doo MX Z Iron Dog, Руководство оператора

Страница: 71 / 147

BASIC PROCEDURES
WARNING
Make sure tether cord cap is re-
moved before standing in front the
vehicle, getting close to the track
or rear suspension components.
NOTE: Warm-up is electronically con-
trolled. During this period (up to 10
minutes depending on ambient tem-
perature), engine RPM is limited.
Engaging Reverse (RER)
When the engine is running, depress-
ing the RER button will slow down en-
gine RPM to almost a stop and advance
the ignition timing to invert crankshaft
rotation.
– Engine will automatically shift into
forward when restarting after stop-
ping or stalling.
– Shifting procedure will take place
only when the engine is running.
– If engine is running at a speed above
4300 RPM, the function of the RER
button is disabled.
– It is recommended to warm up the
engine to its normal operating tem-
perature before shifting.
Shifting in Reverse
1. Bring vehicle to a complete stop.
2. Apply and hold brake. Remain
seated, refer to RIDER POSITION
(REVERSE OPERATION)
for pos-
ture information.
3. With engine at idle speed, press and
release the RER button.
4. Wait until reverse beeper sounds,
then gently depress throttle lever.
WARNING
Engaging the reverse mode is
done
by depressing the RER
button when the engine is run-
ning. Wait until the reverse alarm
sounds and the RER pilot lamp
comes on in the analog/digital
gauge before operating throttle
to proceed in reverse. The reverse
speed is not limited. Always pro-
ceed with caution as fast reverse
could result in loss of vehicle sta-
bility. Come to complete stop be-
fore depressing RER button. Al-
ways remain seated and apply the
brake before shifting. Ensure the
path behind is clear of obstacles or
bystanders before proceeding.
Shifting in Forward
1. Bring vehicle to a complete stop.
2. Apply and hold brake.
3. Press and release the RER button.
4. RER pilot lamp will stop.
5. Apply throttle slowly and evenly. Al-
low drive pulley to engage then ac-
celerate carefully.
Shutting Off the Engine
Release throttle lever and wait until en-
gine has returned to idle speed.
Shut off the engine using either the
emergency engine stop switch or by
pulling off the tether cord cap from the
engine cut-off switch.
WARNING
Always remove the tether cord cap
from engine cut-off switch when
vehicle is not in operation in order
to prevent accidental engine start-
ing or to avoid unauthorized use
by children or others or theft.
_______________
69