Ski-Doo MX Z Iron Dog, Руководство оператора

Страница: 100 / 147

MAINTENANCE PROCEDURES
Track Alignment
WARNING
Before checking track alignment,
ensure that the track is free of all
particles which could be thrown
out while track is rotating. Keep
hands, tools, feet and clothing
clear of track. Always lift the snow-
mobile on a wide-base stand with
a rear deflector panel. Ensure no
one is standing in close proximity
to the snowmobile, especially at
the rear of the track. Never rotate
track at high speed.
Centrifugal force could cause de-
bris, damaged or loose studs,
pieces of torn track, or an en-
tire severed track to be violently
thrown backwards out of the tun-
nel with tremendous force.
1. Lift rear of vehicle and support it off
the ground.
CAUTION Use proper lifting
techniques, notably using your legs
force. Do not attempt to lift the rear
of vehicle if it is above your limits.
2. Start engine and accelerate slightly
so that track slowly turns. This must
be done in a short period of time (15
to 20 seconds).
3. Check that the track is well cen-
tered; equal distance on both sides
between edges of track guides and
slider shoes.
A01F05A
1
2
3
1. Guides
2. Slider shoes
3. Equal distance
4. To correct track alignment:
4.1 Stop engine.
4.2 Remove tether cord cap from
engine cut-off switch.
WARNING
Remove tether cord cap from
engine cut-off switch before
performing any maintenance
or adjustment, unless other-
wise specified. Vehicle must
be parked in a safe place,
away from the trail.
4.3 Loosen rear wheel retaining
screws.
4.4 Tighten adjustment screw on
side where the slider shoe is
the farthest from the track in-
sert guides.
A01F0BA
1 2
3
1
1. Guides
2. Slider shoes
3. Tighten on this side
5. Tighten retaining screws.
WARNING
Properly tighten wheel retaining
bolt, otherwise wheel may come
off and cause track to “lock”.
98
______________