3
(C) Copyright 2010-2014 SKD System AB
Sensors
Connect sensor to Rhone2 with patch cable and determine where to position sensors.
Move hand in front of the sensor. Sensor will turn red at detection of movement.
When suitable position of the sensor is determined, fix sensor to the surface using screws or Velcro closing.
On workplace, sensor will typically be fixed under the workdesk, close to the edge.
If sensor is not reacting as intended, move sensor closer to the user or use sensor with wider coverage.
NOTE: At power on, sensor calibrates itself automatically to the evironment. This takes around half minute.
USB control
Download app skdRhone2 from Google Play.
Connect Android device to Rhone2 using USB cable.
skdRhone2 starts automatically when USB cable is connected.
Android device is normally notified by Google play on skdRhone2 uppdates. Otherwise, check Google play for latest release.
LAN control
Standard configuration
If local gateway ip address is 192.168.1.1, connect Rhone2 to LAN with path cable and turn on power.
Rhone2 is ready for operation.
Access modes
Web page (http). Can be accessed from PC, control system, Android. Default link http://192.168.1.222
TCP port 60000. Can be accessed from PC, control system, Android. Use Serial Terminal application in PC. TCP can also
be accessed directly from PC application, from app or via scripted interfaceThere are also many examples of script interface.
There are many simple examples of how to communicate over serial interface using scripting language Python.
Indirect WiFi access from laptop, PC or Android. For access from Android use app skdRhone2 which can be downloaded
from Google play.
Configure LAN
from app
Configure Rhone2 LAN from Android SmartPhone or Tablet
Install skdRhone2 app. When Android device is connected to Rhone2 with USB-cable, the app will start and connect to
Rhone2 automatically.
Next, select Network page and set New IP, New Gateway and/or New MASK.
Next, select "Activate" icon to activate the changes in Rhone2.
Finally, reset Rhone2 by turning power to the product on/off.
If skdRhone2 is not installed in Android. Install skdRhone2 from Google play.
skdRhone2 is designed for Android version 4.0 and later.
Configure LAN
from web page
Configure Rhone2 LAN from PC via web
Connect Rhone2 directly to PC with patch cable.
Via Network configuration in PC, set gateway address in PC to 192.168.1.1.
Start web browser, enter link: http://192.168.1.222.
Select Config page and set new ip, new gateway and/or new mask address.
Then activate the change by selecting "Activate" icon.
Only the ip, gateway and mask values which are not 0.0.0.0 are activated.
Finally, reset Rhone2 by turning power to the product on/off.
Alternative method of configuring LAN parameters is by activating DHCP client in Rhone2.
