Battery Operation
Charging the battery
To charge the battery, insert the charger plug
into the jack on the pump and the charger into
a wall outlet. A red LED will flash on the pump
display to indicate the unit is charging. When
charging is complete, the LED will stop flash-
ing and the pump will go to sleep. The Quick-
Take 15 can be operated using AC power with
battery.
See Operation, To operate from AC power
.
The battery charges completely in five hours.
• The pump will not sleep during charging. Connecting a sleeping pump to
the charger will wake it up from sleep.
• The AC charger/adapter can be used to extend battery run time, but it is not
a battery eliminator. Therefore, it will not provide indefinite run times.
Installing a Replacement Battery
1. Remove the six screws from
the battery compartment
cover.
2. Lift out the battery pack and
disconnect it.
3. Connect the new battery
pack and insert it into the
battery compartment.
4. Re-attach the battery
compartment cover with
the six screws.
Screws
Screws
Battery
pack
Cautions and Warnings
• To reduce risk of injury, fire, or electric shock, always follow basic safety
precautions when using this product.
• Batteries may explode or leak and cause burn injury if disassembled.
• Use only the approved charger and battery for this product. Mixing this
product with a different battery type or charger may cause damage to the
pump and cause injury if the battery explodes.
Using non-approved batteries
or charger voids the warranty.
• Do not submerge the pump or subject it to any liquids.
Protect sample pump from weather when in use outdoors.
See http://www.skcinc.com/instructions/1721.pdf for more information
on maintaining, disposing, and shipping Li-Ion batteries.
