sitrex QRX 12, Сборка, использование и обслуживание

Страница: 36 / 54

34
2 1
4 3
5
With reference to fig. 4.31 carry out the
operations in the following order:
1) Put the filter locking pin (10) on the
new section (12) in the position
shown, by reversing the operations
in fig.
Errore. L'origine riferimen-
to non è stata trovata. .
2) Insert the plastic bushings (2) into
the pockets (11) of the rake sec-
tions (12).
3) Insert the arm (8) with locking
hole to the section 12 and secure
with the washer (3) and spring pin
(4).
4) Install the nipple (6) M6 into the
threaded hole of the bushings (11).
5) Repeat the same procedure on the
other side of the machine.
Item (2): n° 4 plastic bush ø35-42x26 (ø1"3/8-1"41/64x1"1/64)
Item (3): n° 2 washers ø35-50x5 (ø1"3/8-1"61/64x3/16")
Item (4): n° 2 spring pins 8x50 (ø5/16"x1"61/64) DIN 1481
Item (6): n° 2 grease nipple M6 (15/64")
1) Loosen all the blocks (5) which
support the pipelines (1), (2), (3)
end (4) for their entire length.
2) Remove the hoses (1) e (2) from
the fitting “T” and the hoses (3) and
(4) from the valve.
3) Install the four extension hoses of
the kit in points (1) (2) (3) and (4)
as shown in figure.
Item (1-2-3-4): n° 4 hoses lg.900
(35’’1/2)
4.31
4.32