sitrex QRX 12, Сборка, использование и обслуживание

Страница: 19 / 54

17
STEP 8 - With reference to Fig. 4.10,
carry out the operations in the following
order:
1) Do not remove the packaging from
the springs (11) until the following
assembly stages have been com-
pleted.
2) Insert two nylon bush (9) and
screw in grease nipple (10) on
support (2).
3) Fasten the main section (1) to the
telescoping arm (2) inserting the
pin (5) into the hole (8) and using
the washers (4), (6), bolt (3) and
nut (7).
4) Connect the cylinder attachment
(14) to the section (1) with the pin
(12), spacers (13), washer (15)
and nut (16).
5) Attach the rear section (17) to the
main section (1), fastening it with
the bolts (19) and nuts (18). Insert
the caps (21) in the sections (17).
6) Attach the front section (20) to the
main section (1), fastening it with
the bolts (19) and nuts (18).
7) Repeat the same operations on
the other side of the machine.
Item (9): 2 nylon bush ø85/75x30 (ø3"11/32–2"15/16x1"11/64")
Item (10): 2 grease nipples M8 (5/16")
Item (3): 2 bolts M24x170 (15/16"x6"11/16) DIN 931
Item (5): 2 pins ø75x107 (ø2"15/16x4"14/64)
Item (4): 2 washers ø25/64x10 (ø1"-2"35/64x25/64")
Item (6): 2 washers ø25/90x10 (ø1"-3"17/32x25/64")
Item (7): 2 nuts M24 (1”) DIN 980
Item (12): 2 pins ø20x145 (ø25/32"x5"45/64)
Item (13): 4 spacers ø20/34x33 (ø25/32"-1"21/64x1"19/64)
Item (15): 2 washers ø16 (ø5/8”) DIN 125A
Item (16): 2 nuts M16 (5/8”) DIN 980
Item (19): 12+12 bolts M12x35 (15/32”x1.3’’) DIN 933
Item (18): 12+12 nuts M12 (15/32”) DIN 980
Item (21): 2 plastic caps
4.10