Use and Maintenance Manual
–
002.108A of _27/09/2021
Square Baler
–
M 60 Mini/S
–
M 60 Mini
–
M 60 Super
94
ENGLIS
H
Problem
Cause
Remedy
FIG. A
Correct knot with 2
clean cut ends and no
loop.
FIG. A 2
Knot with loop.
The twine slips too much
in the retainer/twine
holder.
The knife doesn’t cut
properly.
Adjust the holder disc,
Sect. 7.4.2
- Sharpen or replace the
knife.
- Ensure that the ejector
arm is correctly adjusted,
Sect. 7.4.8.
Problem
Cause
Remedy
FIG. B
The twine ends of the
knot are of different
lengths.
The knife is worn.
The twine holder of the
disc does not apply
enough pressure.
The bales are too loose.
Sharpen the knife or
replace it if necessary.
Adjust the holder disc,
Sect. 7.4.2
Adjust the bale density,
Sect. 7.5.3
FIG. C
The knots don
’
t slide
out from the knotter
billhook.
The ejection tongue
does not adhere to the
knotter billhook
The knife holder arm
does not come out of
the knotter billhook.
There is too much
pressure on the tongue
1 of the knotter
billhook.
The knotter billhook is
worn.
Too much pressure in
the bales.
Bend the knife holder arm
until the ejection tongue
rubs against the back of
the billhook. See Sect.
7.4.8.
Adjustment, Sect. 7.4.8.
Decrease the pressure,
making the adjustment
described in Sect. 7.4.7.
Replace the knotter
billhook.
Bale adjustment, Sect.
7.5.3.
