Use and Maintenance Manual
–
002.108A of _27/09/2021
Square Baler
–
M 60 Mini/S
–
M 60 Mini
–
M 60 Super
53
ENGLIS
H
Fig. 7.8
The lower right corner guide 11 (Fig. 7.8) is fixed and is mounted on the bale chamber with the
insertion of the shims 5 and 7 (Fig. 7.8). If the lower right guide is fairly worn, the guide must be
removed and other shims inserted to compensate.
If the lower right guide shows considerable wear and allows play, it is necessary to remove the guide
and replace it with a new one, inserting the original shims.
Work on the lower right guide must be done out with the carriage disassembled and before doing any
possible work on the left guides.
The upper right side guide is fixed and is fastened to the bale chamber with screws. Any excessive
play that occurs between the plastic slide block 6 (Fig. 7.8) and the aforementioned guide is
compensated by moving the slide block in question by means of adjustment and fastening screws so
that there is a maximum play of not more than 0.5 mm.
In the same way, it is necessary to make adjustments to compensate for any play produced between
the slide block 6 and its upper right guide 9 (Fig. 7.8).
The plunger height can be adjusted using the eccentric pins of the 4 journal bearings 12 (Fig. 7.8),
after having removed the plunger from the bale chamber.
In the event that the guides on which the plunger slides are clogged with soil or other materials, it is
necessary to remove the plunger from the bale chamber and clean the guides or, if necessary, remove
the guides, clean them and reassemble them.
