DCN: 140-02302-01
Page 11
Operation Guide
Model TM46
SiteSage Thermostat
MENU
COOL
MODE
72 H
AUTO
FAN
HOLD
75
2
75 C
4:30 PM
SYS
Off
Fan Off
Hold
Temperature
Setting
Warmer
Cooler
Fan Mode
Selection
Heating/Cooling
Mode Selection
Run/Hold
Mode Selection
Menu
Selection
Room
Temperature
Setpoints
Backlite Display
Main Thermostat Screen
Minimized Display
Press any button to return to the main thermostat screen
75
Thermostat Name
Zone Name
Mi-Wi Signal
Strength
DCN: 140-02302-01
Page 12
Setting the heating or cooling temperature setpoint
!
If the System Mode is OFF, pressing either the Up or Down buttons will take you
to the System Mode screen. You must first set an operating mode before you can
set or change the setpoint.
!
To change the Heat Setpoint you must be in the Heating mode, to change the Cool
Setpoint you must be in the Cooling mode. If you are in Auto mode, the mode of the
last system call will be the setpoint screen displayed.
Setpoint Push:
Note that you cannot lower the cooling setpoint below the heating
setpoint. The thermostat will “push” the heating setpoint lower if you try to lower the
cooling setpoint below the heating setpoint. It maintains a 3 degree separation between
the heating and cooling setpoint. The same is true for raising the heating setpoint above
the cooling setpoint. Again the thermostat will “push” the cooling setpoint up to maintain
the 3 degree separation.
Lower Temperature
Raise Temperature
Press a button to
go to the setpoint
change screen
Setpoint change screen
Press “DONE” button to set the setpoint and exit back
to the main thermostat screen or wait for the screen to
automatically time out.
Press the up or down arrow buttons to
set the desired temperature setpoint
HEATING SETPOINT
Pressing the up
or down buttons
will increment the
setpoint 1 degree.
Press and hold
the button to
ramp the setpoint.
75
MENU
HEAT
MODE
HOLD
64H
82C
AUTO
FAN
Sys Off
70
Done
Thermostat Name
