Document NO.: RD-529-39-001
Version: A
- 4 -
Maintenance and Cleaning:
In addition to weekly testing, the alarm requires periodic
cleaning to remove dust, dirt, and debris. Clean the alarm at
least once a year to remove dust, dirt, or debris. Use a
vacuum cleaner with a soft brush, vacuum all sides and
covers of smoke alarm. This alarm has a low battery monitor
which will cause the alarm to “chirp” approx every 50
seconds and the red LED flashes once at the same time for a
minimum of 7 days when the battery gets low. If there is a
defective battery or other failures, you can refer to “Trouble
shooting” for solution, if there are still failures during
warranty, you can return to your retailer.
IMPORTANT:
Do not attempt to remove the cover to clean
inside. This will void the warranty.
Repair:
Caution: Do not attempt to repair the alarm. It will affect
your warranty.
If the alarm is not operating properly, and is still under
warranty, return it to the original place you buy. Pack it in a
well-padded carton, and ship to the original place you buy.
If the alarm is no longer under warranty, have a licensed
electrician replace it immediately with a comparable alarm.
Trouble shooting:
DO NOT disconnect battery to quiet an unwanted alarm. This
will remove your protection. Fan the air or open a window to
remove smoke or dust.
Problem
Cause and Remedy
Smoke alarm does not
sound when tested.
1.Clean smoke alarm. Please refer to
the “maintenance and cleaning”
section.
2.If problems persist and the unit is
still under warranty, you can return to
your retailer.
3. If the unit is out of warranty
，
please
replace another new alarm.
Smoke alarm beeps
with the red LED
flashing about once
50
seconds.
The battery is depleted, please replace
the battery
Smoke alarm chirp
occurs every 50
seconds
（
alarm goes
into fault mode
）
.
Clean smoke alarm. Please refer to the
“maintenance and cleaning” section.
Replace the alarm if the problem
persists
Smoke alarm sounds
unwanted alarms
intermittently or when
residents are cooking,
taking showers, etc.
1. Press test button to silence alarm.
2. Clean smoke alarm. Please refer to
the “maintenance and cleaning”
section.
3. Move smoke alarm to new location
and press test button.
The
alarm
sounds
different from it is
used to. It starts and
stops.
1. Clean smoke alarm. Please refer to
the “maintenance and cleaning”
section.
2. If the problem persists during
warranty, you can return to your
retailer.
3. if the unit is out of warranty
please replace another new alarm.
DEVELOP AND PRACTICE A PLAN OF
ESCAPE
