5
1
、
Chosing the operation mode of the system
1.1 Mode description
The system have 2 operation mode,it is master mode and slaver mode.in
master mode under surveillance,if the people enter into the first sensor
surveillance place,it will automatically alarm,if the people enter into the
second sensor surveillance place,it will also automatically spray the pepper.
in slaver mode under surveillance,if the people enter into surveillance
place,it will only send the wireless signal to the master and will not alarm,it
will not spray the pepper also.
1.2 Mode switch
On the rear of the top cover,it had 4pcs of circuitry board,one of the largest
circuitry board is the main control board(see figure 4),if you insert the mode
switch To M,it is master mode,if you insert to S,it is slaver mode,the default
mode is master mode.
2
、
Remote controller study
2.1 The 2 remote controllers with the system already studied,you can use
directly.If you think 2 remote controllers are not enough,and want buy more
remote controllers,after you bought it,you need let those remote controllers
study.otherwise,you can
’
t control the system(the remote controllers you can
buy from our distribution)
2.2 Study procedure
2.21 Please find the dial switch on the main control circuitry board,it had 2
dial code on the dial switch,it is work and study code, please dial work
code to
”
1
”
, ,dail study code to
“
N
”
,it indicate the system turn into the study
mode.meanwhile,you will see the study light will be yellow.
2.22 Press any button on the remote controller,it will beep 2 times and you
will see the study light will be green,then the study light will go out and turn
into yellow,it indicate the study is finished.if it is a long beep. while in
studying,and the study light turn into red.then going out and turn into
yellow,it indicate the study is failed or the remote controller already
studied.Repeat again this procedure till to finish the remote controller
which needs to study.
2.23 After all the remote controllers finish to study.dail the work code
to
”
O
”
,dail the study mode to
”
2
”
,it indicate the system turn into the operation
mode(the default mode is operation mode),meantime,the study light will go
out.please press the
”
OFF
”
button on the remote controller.the study light will
immediately flash green.It indicate the study completely succeed.if it flash
red,it indicate the study is failed,please study again.
