SISTEM AIR AUTO Jet TURBIX, Техническое руководство

Страница: 8 / 24

Auto Jet Instruction Manual
8
19/04/2018 Rev:2.0.0
CENTRAL VACUUM SYSTEMS
ByTecnoplus
s.r.l.
4 - SAFETY FEATURES
It is recommended to read carefully all of the instructions relative to installation, use and maintenance
contained in this manual.
Moreover, the following WARNINGS must always be followed:
• In case of maintenance:
- disconnect the appliance from electrical power supply
- close the AUTO Jet compressed air system
- discharge the pressurized air present in the AUTO JET system
• Do not use the appliance for improper use.
• Do not allow children to approach the equipment
• This appliance must not be used by persons (including children) with reduced intellectual, sensory
or mental abilities, or by persons without experience and knowledge, unless they are supervised, or
instructed to use the appliance by persons responsible for their safety.
• Wear protective gloves and a mask to perform maintenance work,
• Use only original spare parts
Finally, remember that pictograms or signs of danger and prohibition are found in the parts of the equip-
ment where, if you do not comply with the conditions dictated by the warnings, you can certainly create
unsafe situations.
WARNINGS: TECNOPLUS S.R.L. declines any form of responsibility or warranty if the purchaser or for
those who make changes or modifi cations to the product purchased, albeit minimal.
The equipment thus designed and manufactured is able to satisfy the current needs of the centralized
household suction market regarding both quality and application.
All materials and components used for its construction meet the CE safety standards and the certifi -
cates are held at the offi ces of TECNOPLUS S.R.L.
Finally, through the three potentiometers on the control panel it is possible to adjust the following
operating parameters:
- suction timing (to avoid excessive fi lling of container)
- aperture opening timing (to be set according to the specifi c weight and consistency of the vacuumed
material)
- compressed air jet timing which operate in emptying phase
Using the TEST button it is possible to test these three settings immediately, in order to fi nd the optimal
settings based on the type of vacuumed materials.