SISTEM AIR 3107.1TER, Техническое руководство

Страница: 29 / 42

2
12/05/16 Rev:1.0.0
2 - Connection to the piping network (bag suction)
1. If the service suction inlet is already assembled on the body of the appliance remove it being careful
not to damage the inserted gasket.
2. In case of
¿
rst installation, the body of the vacuum cleaner body is completely disconnected; for this
reason, install the elbow coupling, provided with the kit, in the lower hole, being careful to position
the sealing gasket in the internal side between the coupling and the body.
3. By means of the screws and washers provided in the BI-VAC kit, screw the elbow coupling to the
appliance body on the outer side of the cylinder.
4. Remove the conveyor cone from the dust collection bin.
5. Position the ring seal with gasket in the special housings in the internal sides of the machine body.
6. Insert the bag, being careful to put it at the bottom end of the elbow coupling.
7. Repeat the steps described in the previous paragraph being careful to connect the pipe coming from
the pipe network to the end of the elbow coupling on the appliance body (E).
8. Place the closing cover (F) at the end of the coupling of the cyclonic dust suction inlet, (see the draw-
ing) since it will be no longer used; leaving this open will break-off the system suction power.
3 - Replacing the dust bag (bag suction)
Switch the vacuum cleaner off by pressing the ON/OFF switch.
Disassemble the dust container
1
E
F
3
English