OIL DISPENSING SYSTEM AIR OPERATED
MODEL NO:
AK4562
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
1.
SAFETY
WARNING!
Ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using this
equipment.
9
Familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to this product.
9
Maintain the pump station in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Non authorised parts will invalidate the warranty.
9
Use only to pump lubricants up to SAE 150 viscosity.
9
Ensure safety eye protection, oil resistant gloves and protective clothing are worn when using this product.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
After use, drain any fluids from the equipment before storage.
9
Dispose of waste liquids in accordance with local authority regulations.
9
Disconnect air pressure from equipment when not in use.
8
DO NOT
exceed the maximum air pressure of 115psi.
8
DO NOT
point the nozzle at people or animals.
8
DO NOT
use the equipment near open flames.
8
DO NOT
smoke whilst using this equipment.
8
DO NOT
use to extract corrosive fluids.
8
DO NOT
dismantle, tamper with or adapt the pump for any purpose other than for which it is designed.
8
DO NOT
use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
8
DO NOT
leave the trolley on a slope, or traverse slopes, which may cause the unit to topple.
9
The unit must be stored on a level surface.
9
Keep the pump clean and store in a safe dry, childproof location.
WARNING! DO NOT
allow uncontrolled discharge of fluids thus polluting the environment. All liquids must be disposed of according to
authority regulations.
2.
i
INTRODUCTION
Mobile oil dispensing unit with air operated 3:1 double acting pump for barrels or
tanks with 2”BSP fittings. Pump is supplied with air management system
connected to a 940mm rigid suction probe with non-return valve. Features
10mtr retractable hose reel and digital oil meter Model No. AK4565D. Suitable
for use with engine, hydraulic, synthetic, gear, and transmission oils up to SAE150.
3.
i
SPECIFICATION
Model No: ...............................................................AK4562D
Maximum Air Pressure: ................................................115psi
Maximum Flow Rate: ............................................... 12ltr/min
Maximum Output Pressure: ........................................ 350psi
Maximum Trolley Capacity: .......................................... 220kg
Maximum Viscosity: .................................................. SAE150
Nett Weight: ................................................................72.6Kg
O
utlet Size:
...............................................................1/2”BSP
Pump Ratio: ...................................................................... 3:1
Recommended Air Pressure: ........................................ 70psi
Digital Hose End Meter
Model ......................................................................AK4565D
Accuracy: ..................................................................+/- 0.5%
Inlet: ..........................................................................1/2”BSP
Battery: ......................................... Lithium CR2 3V 1400mAH
AK4562D Issue 3 (H, 5, F) 24/09/18
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear protective
gloves
Wear eye
protection
Wear protective
clothing
Wear safety
footwear
