Instruction manual TECNO line
14
12/05/16 Rev:1.0.0
CENTRAL VACUUM SYSTEMS
ByTecnoplus
s.r.l.
Put the conveyor cone back in position
4
Reassemble the dust bin inside its housing under the suction system and lock the closing handles.
Switch the suction system on by pressing the ON/OFF switch.
After re-starting the system push the “RESET” button to reset the dust bin alarm.
Remember to take care when emptying the bin: if there is a huge quantity of dust, make sure you
do not throw away the conveyor cone. Always check that the conveyor cone is still in place and
correctly assembled in its housing inside the bin.
7.6 Disposal of the
fi
lter cartridge
The fi lter cartridge can be reused after washing under running water.
ATTENTION: before replacing the
fi
lter cartridge back in the system after washing, ensure it has
completely dried. DO NOT reassemble the
fi
lter cartridge if the surface is still wet or damp.
Check the fi lter surface is not cut. If this
is the case, the cartridge should not be
used again and should be defi nitely replaced.
2
Before washing the cartridge it is always
recommended to vacuum clean the dirty
surface with an auxiliary suction cleaner
or with the utility/service inlet, remembering
to insert a spare cartridge in the
system before use.
1
ATTENTION
YOU SHALL ALWAYS CHECK THE RIGHT POSITIONING AND TIGHTENING OF THE FILTER
CARTRIDGE. A WRONG POSITIONING OR A LOOSE FILTER CARTRIDGE MAY CAUSE A SE-
RIOUS DAMAGE OF THE PRODUCT.
DO NOT USE THE VACUUM CLEANER WITHOUT THE FILTER CARTRIDGE. ENSURE YOU
HAVE REPLACED A SPARE FILTER CARTRIDGE BEFORE CARRYING OUT THIS OPERATION.
Содержание 3107.1TER
Страница 2: ......
