8.4 Modifying the personalised maintenance parameters
The following procedure allows you to modify the personalised maintenance parameters.
ATTENTION: Any new change will cancel the previously inserted data.
1 - Verify that the machine is connected to the main power supply but not running,
(the led is off and the led is on).
2 - Keep the button pressed for approximately 5 seconds.
the led and will switch on.
3 - CHANGE OF THE CLEANING FILTER TIMING: Press the button until the
FILTER led switches on. The programmed number of hours will be
displayed. Press buttons or to increase or decrease the value.
Confirm the change by pressing the button (see reference values at pag.
23)
4 - CHANGE OF THE DUST CONTAINER UNLOADING TIMING: Press the button
until the DUST CONTAINER led switches on. The programmed
number of hours will be displayed. Press buttons or to increase or
decrease the value. Confirm the change by pressing the button (see
reference values at pag. 23).
5 - CHANGE OF THE MOTOR MAINTENANCE TIMING: Press the button until
the MOTOR MAINTENANCE led
switches on. The programmed
number of hours will be displayed. Press buttons or to increase
or decrease the value. Confirm the change by pressing the button (see
reference values at pag. 23).
6 - By pressing the button you go back to step 3 .
7 - To exit, press the button or switch the machine on by opening a
suction inlet or by closing the micro switch line.
28
Installation, use and maintenance guide
TA-TE 02/04-01
ON
POWER
PROG
PIN
RESET
