8.3 Displaying of the personalised maintenance parameters
The following procedure allows to display the personalised maintenance parameters
without changing the set values.
1 - Verify that the machine is connected to the main power supply but not running,
(the led is off and the led is on).
2 - Keep the button pressed for approximately 5 seconds.
The led and will switch on.
3 - DISPLAY OF THE PIN CODE: press repetitively the button to scroll the
programmed PIN code number.
4 - DISPLAY OF THE CLEANING FILTER TIMING: press the button . The led
will switch off and the led FILTER CLEANING will switch on.
The programmed number of hours will be displayed (see reference values at
pag. 23).
5 - DISPLAY OF THE DUST CONTAINER UNLOADING TIMING: press the button
. The led will switch off and the led DUST CONTAINER
will switch on.
The programmed number of hours will be displayed (see reference values at
pag. 23).
6 - DISPLAY OF THE MOTOR MAINTENANCE TIMING: press the button
. The led will switch off and the led MOTOR MAINTENANCE
LED will switch on.
The programmed number of hours will be displayed (see reference values at
pag. 23).
7 - By pressing the button you go back to step 3 .
8 - To exit the display press the button or switch the machine on by
opening a suction inlet or by closing the micro switch line.
27
Installation, use and maintenance guide
TA-TE 02/04-01
ON
POWER
PROG
PIN
PIN
RESET
