23
2
English
27/05/14 Rev:1.0.0
Reassemble the dust bin inside its housing under the suction system and lock the closing handles.
Switch the suction system on by pressing the ON/OFF switch.
Remember to take care when leaving the bin: always check that the bin gasket support is still in
place and correctly assembled in its housing inside the bin.
12.3 Dust collection, transfer and disposal
Where a separated refuse collection policy is in place, once removed from the vacuum cleaner, the dust
collected in the dust bags must be placed in the green “dry, non-recyclable waste” bins.
12.4 Disposal of the
fi
lter cartridge
The
fi
lter cartridge can be reused after washing under running water.
ATTENTION: before replacing the
fi
lter cartridge back in the system after washing, ensure it has
completely dried. DO NOT reassemble the
fi
lter cartridge if the surface is still wet or damp.
Check the
fi
lter surface is not cut. If this
is the case, the cartridge cannot be used
again and must be de
fi
nitely replaced.
2
Before washing the cartridge it is always
recommended to vacuum clean the dirty
surface with an auxiliary suction cleaner
or with the utility/service inlet, remembering
to insert a spare cartridge in the
system before use.
1
ATTENTION
YOU MUST ALWAYS CHECK THE RIGHT POSITIONING AND
TIGHTENING OF THE FILTER CARTRIDGE. A WRONG POSITION-
ING OR A LOOSE FILTER CARTRIDGE MAY CAUSE A SERIOUS
DAMAGE TO THE PRODUCT.
DO NOT USE THE VACUUM CLEANER WITHOUT THE FILTER
CARTRIDGE. ENSURE YOU HAVE REPLACED A SPARE FILTER
CARTRIDGE BEFORE CARRYING OUT THIS OPERATION.